Knowledgebase: Troubleshooting
I connected a device to the SFD port of my Flex/Solid device, but it isn’t working after installation. What could be wrong?
Posted by Squarell Support on 09 December 2013 10:09 AM

The SFD devices require one powercycle of the interface device to be able to recognize a newly connected SFD device. So after connecting a DAP, DatacliQ for CANbus, DatacliQ for J1708, Trailer Data Interface or Fuel Level Sensor device to the SFD port, always re-power the Flex or Solid devices.

Comments (0)